ISO 16121-3:2011

INTERNATIONAL ISO
STANDARD 16121-3
Second edition
2011-08-01


Road vehicles — Ergonomic
requirements for the driver's workplace in
line-service buses —
Part 3:
Information devices and controls
Véhicules routiers — Exigences ergonomiques du poste de conduite
dans les bus de ville —
Partie 3: Systèmes de contrôle et d'information




Reference number
ISO 16121-3:2011(E)
©
ISO 2011

---------------------- Page: 1 ----------------------
ISO 16121-3:2011(E)

COPYRIGHT PROTECTED DOCUMENT


©  ISO 2011
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means,
electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or
ISO's member body in the country of the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail copyright@iso.org
Web www.iso.org
Published in Switzerland

ii © ISO 2011 – All rights reserved

---------------------- Page: 2 ----------------------
ISO 16121-3:2011(E)
Contents Page
Foreword .iv
Introduction.v
1 Scope.1
2 Normative references.1
3 Terms, definitions and abbreviated terms.1
3.1 Terms and definitions .1
3.2 Abbreviated terms .3
4 Checking and information devices.5
4.1 Basic ergonomic principles .5
4.2 ISO 4040 compatible location .5
4.3 Zone A.6
4.4 Zone B.6
4.5 Zone B (where available).6
1
4.6 Zone C.6
4.7 Zone C (where available).7
1
4.8 Zone D.7
4.9 Zone E.7
4.10 Zone F.7
5 Adjustable dashboard.8
Bibliography.9

© ISO 2011 – All rights reserved iii

---------------------- Page: 3 ----------------------
ISO 16121-3:2011(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies
(ISO member bodies). The work of preparing International Standards is normally carried out through ISO
technical committees. Each member body interested in a subject for which a technical committee has been
established has the right to be represented on that committee. International organizations, governmental and
non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the
International Electrotechnical Commission (IEC) on all matters of
...