EN 362:2004
(Main)Personal protective equipment against falls from a height - Connectors
Personal protective equipment against falls from a height - Connectors
This European Standard specifies the requirements, test methods, marking and information supplied by the manufacturer for connectors. Connectors conforming to this European Standard are used as connecting elements in personal fall protection systems, i.e. fall arrest, work positioning, rope access, restraint and rescue systems.
Persönliche Schutzausrüstung gegen Absturz - Verbindungselemente
Dieses Dokument legt die Anforderungen, Prüfverfahren, Kennzeichnung und Informationen des Herstellers für Verbindungselemente fest. Verbindungselemente nach dieser Europäischen Norm werden als Verbindun¬gen in persönlichen Absturzsicherungssystemen, z. B. Auffang-, Halte-, Rückhalte-, Rettungs¬systemen und Systemen für seilunterstützte Arbeiten eingesetzt.
Équipement de protection individuelle contre les chutes de hauteur - Connecteurs
La présente Norme européenne spécifie les exigences relatives aux connecteurs, ainsi que les méthodes
d�essai, le marquage et la notice d�information du fabricant. Les connecteurs, conformément à la présente
norme européenne, sont utilisés avec les protections individuelles contre les chutes comme par exemple, les
systèmes d�arrêt des chutes, les systèmes de maintien au poste de travail, les systèmes de retenue et les
systèmes de sauvetage.
Osebna varovalna oprema za zaščito pred padci z višine – Spojni elementi
General Information
Relations
Standards Content (Sample)
SLOVENSKI STANDARD
SIST EN 362:2005
01-april-2005
1DGRPHãþD
SIST EN 362:1996
2VHEQDYDURYDOQDRSUHPD]D]DãþLWRSUHGSDGFL]YLãLQH±6SRMQLHOHPHQWL
Personal protective equipment against falls from a height - Connectors
Persönliche Schutzausrüstung gegen Absturz - Verbindungselemente
Équipement de protection individuelle contre les chutes de hauteur - Connecteurs
Ta slovenski standard je istoveten z: EN 362:2004
ICS:
13.340.60 =DãþLWDSUHGSDGFLLQ]GUVL Protection against falling and
slipping
SIST EN 362:2005 en
2003-01.Slovenski inštitut za standardizacijo. Razmnoževanje celote ali delov tega standarda ni dovoljeno.
---------------------- Page: 1 ----------------------
SIST EN 362:2005
---------------------- Page: 2 ----------------------
SIST EN 362:2005
EUROPEAN STANDARD
EN 362
NORME EUROPÉENNE
EUROPÄISCHE NORM
December 2004
ICS 13.340.99 Supersedes EN 362:1992
English version
Personal protective equipment against falls from a height -
Connectors
Équipement de protection individuelle contre les chutes de Persönliche Schutzausrüstung gegen Absturz -
hauteur - Connecteurs Verbindungselemente
This European Standard was approved by CEN on 20 October 2004.
CEN members are bound to comply with the CEN/CENELEC Internal Regulations which stipulate the conditions for giving this European
Standard the status of a national standard without any alteration. Up-to-date lists and bibliographical references concerning such national
standards may be obtained on application to the Central Secretariat or to any CEN member.
This European Standard exists in three official versions (English, French, German). A version in any other language made by translation
under the responsibility of a CEN member into its own language and notified to the Central Secretariat has the same status as the official
versions.
CEN members are the national standards bodies of Austria, Belgium, Cyprus, Czech Republic, Denmark, Estonia, Finland, France,
Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Slovakia,
Slovenia, Spain, Sweden, Switzerland and United Kingdom.
EUROPEAN COMMITTEE FOR STANDARDIZATION
COMITÉ EUROPÉEN DE NORMALISATION
EUROPÄISCHES KOMITEE FÜR NORMUNG
Management Centre: rue de Stassart, 36 B-1050 Brussels
© 2004 CEN All rights of exploitation in any form and by any means reserved Ref. No. EN 362:2004: E
worldwide for CEN national Members.
---------------------- Page: 3 ----------------------
SIST EN 362:2005
EN 362:2004 (E)
Contents
page
Foreword.3
1 Scope .4
2 Normative references .4
3 Terms and definitions .4
4 Requirements.7
4.1 General.7
4.2 Static strength.8
4.3 Gate function.8
4.4 Gate resistance (not for class Q-connectors).8
4.4.1 Gate face.8
4.4.2 Gate side.8
4.5 Corrosion resistance.9
4.6 Marking and information.9
5 Test methods.9
5.1 Examination of design .9
5.1.1 General.
...
Questions, Comments and Discussion
Ask us and Technical Secretary will try to provide an answer. You can facilitate discussion about the standard in here.